You need a socket hex head screwdriver to fasten wood to metal with this type of screw.
Attach wood top to metal frame.
How to attach wood to a steel frame building.
You can also drill this screw into the metal and wood using a socket bit on your drill.
My concern is to figure out how to attach the table top without risking it splitting.
Special wings ream a hole in the wood to prevent thread engagement during drilling.
3 roundhead bumper bolts.
Bolt the piece of wood to the steel frame by pre cutting holes into the frame so the bolts can fit through.
Teks wood to metal screws provide secure wood to metal fastening with strong holding power without the need to pre drill.
The metal frame has four holes that are evenly spaced across the top of the frame which i assume were once used to attach the original top.
Screw the enlarged side with a washer and pan head screw just snug it up leaving room for it to move then screw the other side solid.
These roundhead bumper bolts provide wood extra support.
I use a woodworking method s.
Place a washer into the.
Teks wood to metal screws are ideal for attaching roof subfloor decking trailer beds to frame and wood headers to steel frame.
Detailed video on how i build a table top and the clever way i attach it to the base without using any screws of metal hardware.
Drill guide holes to slide the.
2 screwdriver socket hex head.
Popular mechanics recommends drilling at maximum speed and using a screw that is slightly longer than the thickness of your materials.
I recommended to simply make the holes in the metal bracket bigger and to add a washer or use a large headed screw to allow the top to move side to side while still being held down.
I have a salvaged metal frame from a printing press and want to put a nice table top on it.
Screws are usually used to fasten wood piece to each other in indoor or outdoor structures.
The drill point and flute are designed to remove material efficiently and properly size the hole for self tapping threads.
Attaching a wood table top to a metal frame i would suggest enlarging the holes in your brackets on one side of the table.
Roundhead bumper bolts are used to.
Countersink the guide holes 1 4 inch with a spade drill bit.