Attaching Hardie Siding

As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology.

Attaching hardie siding.

Installing siding wet or saturated may result in shrinkage at butt. The siding is installed using the same general techniques as wood siding with planks layered up the side of the building and nailed securely into place. James hardie recommends the use of building paper type weather resistive barriers with all siding products. Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation.

Hardie siding increases the value beauty and durability of your home. And canada who are available to work with any contractor or builder. We have dozens of installation specialists throughout the u s. You have two options here you can make your own or you may be able to find acceptable prefabricated third party starter strips available for purchase.

James hardie is the inventor of hardie siding. From the top edge and no closer than 3 8 in. From the ends of the plank. James hardie recommends installing a rainscreen an air gap between the hardiepanel siding and the water resistive barrier as a best practice.

You can make your own fiber cement starter strip by ripping a piece of hardieplank lap siding into 1 1 4 inch strips. Hardie board siding is a cement board siding that can be installed over braced wood or steel studs on the exterior of a building to provide a strong durable covering that creates the look of wood siding without the expense or maintenance requirements. Fasteners shall be installed between 1 in. James hardie will assume no responsibility for water infiltration within the wall.

Never place a fastener less than 3 4 inch from the top edge of the plank. James hardie recommends that you consult your design professional if you have questions regarding the use of rainscreen on your single family project. The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going.