Transfer cut length dimensions from table 4 to the bottom section of the ladder right and left rails and draw a cutting line between the two points.
Attic stairs trimming bottom section to length.
Step 4 cut each bottom stringer to the proper length along the lines drawn.
Greenville pa 724.
Step 5 check to make sure the stairs fit flush with the floor and that all joints are tight with no gaps fig.
A gap like this could also result from a bottom section that has not been properly trimmed to fit.
During the installation process depending on your floor to floor height you might have needed to install additional stops.
Built for safety this sturdy wood ladder makes it easy to access your attic with nine non slip steps and a convenient handrail for support while climbing.
Push down on the top and second joints to make sure the stairs are extended properly.
The bottom section of the stairs should fit flush with the floor on both sides after cutting.
Fold the bottom section of ladder out of the way.
Weight capacity designed to fit ceiling heights from 8 ft.
Press down on the climbing section to insure that the power arms are fully extended.
Mark and cut the bottom section of the ladder cutting the rails at an angle to match the floor.
Trim bottom section to length using wood saw.
Trim bottom section to length using a metal cutting saw figure 7.
Rotate bottom section back in line with top sections and press down on the middle section to ensure that the power arms.
A new bottom.
Trimming bottom section to length see figure 5.
The werner wood universal fit attic ladder features the werner wood universal fit attic ladder features a 250 lb.
Drill 1 16 pilot holes.
And standard ceiling openings of 22 5 in.
Install rubber tread to bottom ends of rail using 1 screws provided.
Nail the trim into the door jamb of the attic stairs by driving the 4d nails through the bottom of the trim where it is thinner it should make contact with the jamb frame of the attic stairs.
Pull down the folding attic stairs.
D transfer these dimensions to the bottom section of the ladders right and left rails and draw a cutting line between the two points.
Metal folding stair model 2200 werner co.
Fold open the top two sections but keep the final section folded up.
Each section of the ladder has 2 different positions to catch onto the other section so you might need to experiment to find the best height for your attic.
9 trim them again.
Do not use the folding attic ladder.
Photo by kolin smith where to find it.