Attic Furnace Vibration

Vibration tends to increase with time as system components wear down but it can also be present in new installations as a consequence of poor design decisions.

Attic furnace vibration.

When one set of bolts begins to come loose it starts to vibrate as the furnace works. Ignoring this could cause the motor to fail. It sound like to me. Put it in an attic full of blown insulation and you re forcing.

The condenser in your air conditioner works hard to get rid of heat and pressurize refrigerant for the return trip through your house. One proposes suspending the new furnace from the rafters. If you don t have a crawl space or a basement then it can be a challenge to place a furnace on the ground floor of the structure. The air handler is not place in correct location.

This could be an indication that the bearings in the motor need to be oiled or that a piece of one has broken off. Both camps claim that their installation method will reduce noise into the house. It is part of the house which is holder the air handler unit is causing the vibration. It is not the lennox or trane central ac is causing the vibration.

Another cause could be twigs or leaves that have clogged your system. If your furnace is located against a wall this vibration can be carried throughout your house. The electrical contractor in the equipment can also make a chattering sound which can damage other components including the compressor if allowed to continue. Some transformers are louder than others and they all hum to some degree.

If the unit is working fine then most likely it is just a noisy transformer. A rattling noise can mean that your air conditioner is starting to deteriorate and some of its parts are loosening. Excessive vibration can be caused by an oversized compressor or chiller. Two of the contractors propose installing the new equipment on the floor like the original system was installed.

When you place a furnace in the attic to take advantage of its. The original equipment installed when the home was built was supported on the attic floor. If the unit is not working and a hum can be heard it could be a bad indoor fan motor and or capacitor. Over time the fan and the cage that surrounds it can shift or become bent and a banging sound could be the fan clipping the cage.

You had the furnaces raised off the attic floor and it somewhat reduce the vibration. In search of a solution to a vibrating furnace. A furnace in the attic is a design that works for all homes. The answer is a number of different bolt systems.